IPHONE 13 3D RENDERING LEAK REVEALED

IPHONE 13 3D RENDERING LEAK REVEALED

iPhone 13 – On the front, there are also three holes in the notch. Talking about the notch, this time, it is smaller than the previous leak. The launch of iPhones, a new generation of, is likely to occur in a few months. However, currently, some leaks have spread. The tentative name of the upcoming phone is the iPhone 13. The series is said to be getting a big upgrade to the ‘Pro’ version screen. Recently there was a leak from MySmartPrice showing a 3D rendering of the body of the iPhone 13.

As per reports, the Apple iPhone 13 will measure around 146.7 x 71.5 x 7.6 mm. If true, this is a slight change in thickness from 7.4mm on the iPhone 12. However, the design is boxier and almost similar to its predecessor.

Reporting from Gizmochina (14/4), the rendering results show that the rear camera layout has a slight change in its placement. Two large holes, as well as two small holes, are placed diagonally from each other. The large hole is likely the lens camera, while the pinhole is the LED flash and microphone.

On the front, there are also three holes in the notch. Talking about the notch, this time, it is smaller than the previous leak. This is because the speaker unit is moved above the camera. There is no clear information regarding the holes in the notch, but it is most likely an IR camera, dot projector, and front camera.

Apple’s iPhone 13 series is said to have improvements in 2021, such as the Apple A15 chipset, an upgraded ultra-wide camera, Qualcomm X60 5G modem, up to 1 TB of storage, and support for Wi-Fi 6E. There is also a 120 Hz refresh rate on the ‘Pro’ variant.

See also  Analyst: Foldable iPhone won't arrive until 2023

Source: MySmartPrice

Leave a Reply

Your email address will not be published.

Translate »